Extang Tuff Tonno: Ford F150 Flareside 92-96 Manuel d'utilisateur télécharger pdf (Page 2)

Extang Corporation, 1901 E. Ellsworth Rd., Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409, Visit us at: www.extang.com

Place the rail assembly over the side of the truck box. Center

rails evenly between cab and tailgate.

(NOTE: Some applications

have hard rubber risers (square rubber pad.) A riser must go toward tailgate.

Some applications will have a riser at both ends, (most have no riser).

Clamp Spacing (Same for each side)

See the stickers located on each side rail for clamp

position, or refer to the dimensions given below.

Note: Remove stickers after installation.

Insert clamp bolt in place.

Do Not Overtighten

Insert bow onto top or bottom peg.

(Top peg for performance, Bottom for good looks.)

Ends are spring loaded

for easy installation.

Push and hold on

spring end and let the

other end slide on with

the spring action.

SPECIAL

FEATURE:

Two pegs

offer two

height

adjustments.

Note:

Bow End does not

fit between pegs.

When positioning wall plates be sure that they fit correctly against the truck bed wall.

The plates must seat against the bottom of, and parallel to, the wall indentation.

inches

Center middle clamp

Note: Measure all distances from screw hole centers.

Press wall plate

firmly in place.

Allow wall

plates to set

over night.

A. Release lever on both corners of

tailgate rail and tilt rail up.

B. Attach tarp at front by pressing

down on edge of tarp with the palms

of your hands (about only 12 inches

on each side). Then hook tarp to the

tails rail’s groove and click down to

tighten tarp. See close-up.

D. Finish attaching tarp along each side by

pushing down and sliding you hand towards

each corner. You can feel the “grip” action.

C. Close-up of downward rotation of rear

rail. You will feel the “snap” effect and see

it tighten snugly.

PUSH

DOWN

PRESS & SLIDE

YOUR HAND

EASY USE OF TRUCK BED

Tarp may be rolled up and secured with

Velcro® for bulk hauling

Upper

Peg

Lower

Peg

Do Not

Place

Between

the Pegs

After wall plates

have set, insert side

rail clamp all the

way into rail.

Place Clamp

Here

STICKER

1 2

Commentaires sur ces manuels

Pas de commentaire

Extang Tuff Tonno: Ford F150 Flareside 92-96 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Extang Tuff Tonno: Ford F150 Flareside 92-96